Aqua-Hot Cab Heater Install Kit

Required when installing an AH-100 or AH-200 cabin heater in side-by-side or vehicle that does not have an existing heat circuit. Plumbs directly into 22mm, ¾"" or 1"" radiator hoses. Gives control of hot water throughput.Protects against engine overheating and maxamizes heat output.

Kit includes:

• Aqua-Hot DIVERTER MANIFOLD VALVE©
• BARBED FITTING ASSORTMENT: ½"" NPT x ¾""; ¾"" NPT x 1""; ¾"" NPT x 22mm
• BACKING PLATE
• DRILL BIT – #9
• HOLE SAW – 1.5"" with pilot bit
• GROMMET – 1" bore x ¼"" groove
• HEATER HOSE – 10- feet x ¾""
• CONSTANT TENSION CLAMPS – #290
• WORM DRIVE CLAMPS - 20ga
• RED WIRE – 10-feet
• FUSE HOLDER – in-line blade type
• FUSE – 5 amp Spade type
• CONNECTORS – Butt-end 18-22 ga and Tap-splice 18-22 ga
• TEFLON TAPE roll"